Allmatic Wireless Battery Photocell Safety Beam Set

  • Description
  • More Details

Infra Red Safety Photocell Beam Set with Wired Receiver and Battery Operated Transmitter for Automated Gates or Doors

Safety beam set with battery operated transmitter to enable installation where it is not possible to cable across the driveway. The receiver is connected to the control panel power supply as normal and can be powere at 12v or 24v ac or dc.

Batteries for the transmitter are included

Range 8 m
Power supply RX 12/24 Vac/dc
Power supply TX 2 baterías 3,6V 2,7Ah
Maximum absorption 24Vac:
TX < 500 µA
RX 30 mA
Working temperature -20…+55°C

1. GENERAL DESCRIPTION In the photocell AFT25B the transmitter can be powered with two 3.6V 2.7Ah Lithium-Tionyle Chloride batteries or with an external power supply at 12-24 VACDC, selectable with a jumper. The photocell has two terminals in which the output contact of a safety device (e.g. a rubber edge) can be connected, and it is particularly suitable to be used in sliding gates, mounted on the moving wing, allowing to connect the edge safety device without long cables or self-winding cables. Battery life is more than 15 months. The photocell is manufactured in compliance with the European directive 98/336/EEC (EMC).
2. APPLICATIONS In sliding gates or other kinds of installations where cables cannot be used or must be reduced (e.g. in existing installations where a safety device must be added)
Power supply (TX) 2 x 3.6V 2.7Ah Lithium-Tionyle Chloride batteries or external 12 ÷ 24 V ac/dc

Power supply (RX) 12 ÷ 24 V ac/dc Consumption (TX) < 500 µA Consumption (RX) 30 mA

Enclosure ABS Size / Weight 110 x 50 x 25 mm  200g Degree of insulation IP 45

Infrared wavelength 950 nm Relay contact capacity 0,5 A @ 24 V ac/dc

Infrared beam range 25 m nominal (8 m in external use )

Working temperature -20 +55° C

Intervention time with photocell beam interruption  < 40 ms 

Intervention time with actuation of safety edge connected to terminal strip < 60 ms  Restore time < 120 ms