Electric Gate Accessories

Radio transmitters, remote controls, safety photocells, keyswitch, loop detectors etc for automatic gates

!
V2 SpA
Larger picture

Remote Control Transmitter TRC4

V2 TRC 4 transmitter for use with all our V2 electric gates kits and radio control products 
Vidue Elettronica TRC4 Gate Automation Keyfob
V2 SpA
Larger picture

TSC4 Radio Transmitter

V2 TSC4 transmitter for use with our V2 gate automation equipment and radio control systems
433Mhz gate and garage door radio controller for V2 systems
V2 SpA
Larger picture

Phoenix2 Transmitter

Slimline 433Mhz V2 transmitter for use with our V2 gate and radio control systems
Phoenix 2 two button remote control
V2 SpA
Larger picture

Phoenix 4 Transmitter for Electric Gates

Phoenix4 4 button transmitter for our V2 gate automation and radio control systems
V2 Phoenix 4 433mhz Electric gate or garage door transmitter
Larger picture

V2 Sirmo Digit Wireless Digital Keypad

V2 Wireless Digital Keypad for V2 Gate and Door Systems
This keypad can be used with all our V2 automation and remote control equipment. Powered by standard aaa batteries - a secure and convenient way to add keypad entry to your electric gate installation. This is the new and improved model that replaces the TTNR and is fully compatible with the older unit. Supplied as Contract 111. Please advise us if you require contract 2
V2 SpA
Larger picture

External Antenna for Electric Gate Systems

External antenna for improved range on 433 and 868 mhz radio systems.
Larger picture

Key Switch

The key switch offers an alternative means of operation to the standard remote control or keypad entry for your gates - simple two wire connecion to the control panel
Larger picture

Photocell Safety Beams RIF50

Surface mount Safety Beam Set - 12 or 24 volt

The set consists of a transmitter and receiver creating an invisible safety beam that when broken will prevent your gates closing. Power is usually taken from the gate control panel and this can be 12v or 24v AC or DC

The receiver has both a normally open and a normally closed connection so an additional set can be used to trigger the gate opening if you wish.

Larger picture

Photocell Safety Beams DFN

Surface or Semi Flush mount Safety Beam Set - 12 or 24 volt

The set consists of a transmitter and receiver creating an invisible safety beam that when broken will prevent your gates closing. Power is usually taken from the gate control panel and this can be 12v or 24v AC or DC

Larger picture

Flashing Warning Beacon

Warning Beacon for Gate Systems, most often used in industrial systems to provide visual warning of automatic gate operation
Larger picture

Single Channel Loop Detector

The single channel inductive loop detector senses the presence of a vehicle passing over a ground loop and provides information to the electric gates control panel to trigger the opening action. It can also be set up as a safety device, preventing the gates closure while a vehicle is on the loop.
Larger picture

Twin Channel Loop Detector for Electric Gates

The twin channel inductive loop detector senses the presence of a vehicle passing over a ground loop and provides information to the electric gates control panel to trigger the opening action. It can also be set up as a safety device, preventing the gates closure while a vehicle is on the loop. The twin channel unit is designed to support two ground loops.
Larger picture

Preformed Ground Loop

The preformed ground loop is suitable for use with most inductive loop detectors. It has a 15 mtr lead for connection to the loop controller. The only other part needed to make this loop work is the Loop Detector, which is sold separately. The Preformed Loop comes ready to install under concrete, asphalt, block paved or in gravel drives.